Front panel key ABS/INC. Measure or position your system in absolute mode, switch to incremental mode for relative measurements, and return to the absolute mode with no loss of measurement or accuracy.

Front panel key MON. This key is used to monitor the currently displayed position for change. If the measuring system moves outside a user-defined tolerance, the display will flash all digits and trip a output signal.

Front panel key HOLD.  This key freezes the current reading.

Front panel key SEND.  Pressing this key will transmit the current reading via the SPC output.

Front panel key F1.  This key can be programmed to offset the currently displayed reading.  Up to four different offsets can be used.

Front panel key F2. Pressing this key will transmit a delete command to cancel the previous SPC transmission.

SPC (position) data may be sent using the 10-pin plug on the display's side.  Data transmission can be initiated by pressing the SEND key, or by requesting the SPC data from an external device. Also used for connecting any of our interface products.

Supplied with two AA alkaline batteries. With regular use, these batteries will last 8-12 months.  A low battery indicator appears when battery replacement is needed.  The connectors are also included for powering the readout with 24VDC.*
*A jumper position on the circuit board must be changed for proper operation.

Non-linear error correction.  After installation, the unit may be calibrated in-place using high quality gaging bars. Up to 32 equally spaced correction points can be saved into memory. This yields a VERY high accuracy at a cost much lower than other systems.