Welcome to Accurate Technology's Web Site

Consumer Products are now available at www.digi-kit.com!
 

Home Contact About Us Search
 
Up
Display Specs
 

 


Full Function Panel Mount Display shown

The Panel Mount Readout can be used with all of our measuring systems, except incremental models. 
(Current models use firmware version 2.290 or higher.)

This readout is powered by two D cell batteries or 24VDC.

Features:

bullet

Can display in decimal metric, inches, and fractions (1/16ths, 1/32nds, or 1/64ths)
bullet

Easy Operation: Front panel settings for Power, Units Selection, Zero, and Plus & Minus Offsets.
bullet

SPC (position) data may be sent using the 10-pin plug on the readout's back side.  (Data transmission for this readout model must be initiated by the receiving device.) Also used for connecting any of our interface products.
bullet A low battery indicator appears when battery replacement is needed.

User Programmable Settings Include:

bullet Readout Direction Control
bullet Enable/Disable Calibration
bullet Selectable Resolution
bullet Metric units: mm or cm
bullet Enable/Disable Fractional readout
bullet Scaling Factor (linear multiplier)
bullet Power Off Timing

 

Related Links

Panel Mount Display Specifications

ProScale Model 150

ProScale Model 250

Download A User Manual for this readout

 

 

 

 

 

 

 

 

 

 

 

 

 

 



Copyright © 2001-2008 Accurate Technology, Inc.
Optimized for Internet Explorer (version 5.5 and above) and screen resolutions of 800 x 600 or higher.
Contact webmaster@accurate-technology.com or call 1-800-233-0580 with questions or comments about this web site.