 |
Front panel key ABS/INC. Measure or position your system in
absolute mode, switch to incremental mode for relative measurements, and
return to the absolute mode with no loss of measurement or accuracy. |
|
|
Front panel key MON. This key is used to monitor
the currently displayed position for change. If the measuring
system moves outside a user-defined tolerance, the display will
flash all digits and trip a output signal. |
|
|
Front panel key HOLD. This key freezes the
current reading. |
|
|
Front panel key SEND. Pressing this key
will transmit the current reading via the
SPC AND the RF
output. |
|
|
Front panel key F1. This key can be
programmed to offset the currently displayed reading. Up
to four different offsets can be used. |
|
|
Front panel key F2. This key can be custom
programmed to suit your needs. |
|
|
SPC (position) data
is sent using the 10-pin plug on the
display's side AND via RF transmission. |
|
|
Supplied with two AA Lithium batteries.
Depending on the amount of use and the number of RF
transmissions, the battery life is 1-3 years. A low
battery indicator appears when battery replacement is needed. |
|
|
When ordered as part of a complete measuring
system, the receiver is included. Up to 63 displays can
transmit to the same receiver.*
*Requires a 10:1 or 63:1 receiver model. |
|
|
Encoder Direction Control |
|
|
High Speed Readhead Control |
|
|
Enable/Disable User Calibration |
|
|
Display Resolution |
|
|
Metric units: mm or cm |
|
|
Enable/Disable Fractional readout |
|
|
Enable/Disable decimal inch
readout |
|
|
Scaling Factor (linear multiplier) |
|
|
Automatic Power Off Timer |
|
|
F1 key Offsets (used with multi-station or
multi-position applications) |
|
|
Programmable Output Signal |
|
|
Programmable Upper/Lower Limits Controls |
|
|
Programmable Drift Tolerance |
|
|
Automatic Monitor Mode Timer (on and off) |
|
|
Software Noise Suppression Level |
|
|
RF Display ID |
|
|
RF System ID |
