-
Changeable Scaling Direction: sets the direction of
encoder
motion to give positive or negative readings.
-
Units: Choose from millimeters, decimal inches, or fractions.
-
Easy Operation: Front panel settings for Zero, Plus & Minus
Offsets, Hold, Data Send, and Drift Monitor.
-
Math functions: Sum, Difference, or Arctangent calculations
on the input values.
-
Radius measurement: Select three points along an arc, and
the display calculates the arc radius and length (between selected
endpoints).
-
Offset Disable: Disables recalibration of the display.
-
Scaling Factor: Distance traveled may be multiplied by
numbers between 0.001 and 99.999.
-
Dual Measurement Modes: Measure or position your system in
absolute mode, switch to incremental mode for relative measurements, and
return to the absolute mode with no loss of measurement or accuracy.
-
SPC data may be
sent using the 10-pin plug on the back of the readout.
-
Programmable drift tolerance for
monitoring.
-
Interfaces directly with select Eltron printers.
