Puts an end to inaccurate tape measurements and repeatability problems.

Repeatable to 0.02mm (0.001 inches).

Can be used on the left or right of the saw.

Dual Measurements: With ProStop's display, you can position your system in absolute mode, switch to incremental mode for relative positioning, and return to the absolute mode with no loss of measurement or accuracy.

Scalability: The system supports multiple stop assemblies on the same fence.

Easy Operation: Front panel settings for Zero, Plus & Minus Offsets, and Units Mode.

Choice of Measurement Mode: Digital Displays will display readings in Millimeters, Centimeters, Decimal inches or Fractions (fractions can be displayed in 16ths, 32nds, or 64ths).

Battery Power: Two AA batteries last six months (average); no power wires to install or maintain.

One year warranty for defects in workmanship.
 

A digital scale (affixed to the fence) with a measuring range between 50 inches and 235 inches. Standard measuring ranges are: 50 inches, 94 inches, 118 inches, and 238 inches.  Custom lengths may be ordered up to 238 inches.

A readhead (position sensor) with a 12 inch cable length.  Custom cable lengths may be ordered up to 30 feet.

A General Purpose Digital Display, modified to operate with the inductive measuring technology that ProStop uses.

A sliding flip-stop assembly with a 45/90 stop plate and fine-adjustment control. This assembly is hard-anodized for extra long life.

Installation hardware.

An instruction manual.